Z corp printer

Z print

We learn to program and use the Z coorporation printer

First step is to open an stl file.
Make sure to check the units whenever your are exporting. The should be the same. as your stl file.
If the part is too big the program will tell you to scale your part, and if you are not able to do it maybe you will be in the necessity of cutting your part in 2.
Make sure your part when you justify it its on the bottom and in the left.

Go file 3d print setup, for selecting the printer. Choose serial port.
Check the powder level
How much powder is in the machine, if it is enough or not …
The section is in service: check powder levels.

You can print 2 parts in the same file.
Black areas on the files means that there are holes on your part and the machine is not going to print it.

File print time estimated.. and the its going to tell you the aprox time is going to take the machine to print your file.

These is the control panel of the printer, here you can move, chance powder and depth to your peice.

these are some of the tools you need when you are working with the zprinter. For removing or aplying the powder, etc.

this is how the zprinter looks from the top, that white panel is where the powder remains, and where your file is going to be printed.